Page 1 of 1
B1: Slide show - window when using FullScreen = 1
Posted: Thu Jun 19, 2008 10:25 pm
by Dreamer
Using the following options (below) - the window mode (without a border) is used instead of fullscreen.
# Slide Show Sequence
Timer = 8.000000
Loop = 1
FullScreen = 1
TitleBar = 0
Fit = 1
StrechVideo = 0
High = 1
CenterWindow = 1
ReadErrors = 0
RandomOrder = 1
ShowText = 0
Text = <File> <Filename>
BackgroundColor = 0
FontName = "Arial"
FontBold = 0
FontItalic = 0
FontHeight = -19
TextColor = c0c0c0
TextBackColor = 0
TextPosition = 0
Effect = 0
EffectMask = 16777215
Re: B1: Slide show - window when using FullScreen = 1
Posted: Fri Jun 20, 2008 9:22 am
by xnview
Ok, will be fixed
Posted: Tue Jun 24, 2008 3:40 pm
by Dreamer
Not fixed in beta 2.
Posted: Wed Jun 25, 2008 10:43 am
by xnview
Dreamer wrote:Not fixed in beta 2.
I can't confirm, i have fullscreen
Posted: Wed Jun 25, 2008 7:46 pm
by Dreamer
OK, it doesn't work only if the sld file is manually changed in text editor:
WinWidth = 640
WinHeight = 480
and...
FullScreen = 0 > 1
I'm not sure if it's a bug or not.
Posted: Wed Jul 16, 2008 7:15 pm
by Dreamer
It's still the same. Sometimes it's (much) easier to edit one number in .sld file than re-create the whole slide show (few seconds vs. few minutes). So WinWidth / WinHeight should be ignored if FullScreen = 1, if possible.
Posted: Thu Jul 17, 2008 6:54 am
by xnview
Dreamer wrote:It's still the same. Sometimes it's (much) easier to edit one number in .sld file than re-create the whole slide show (few seconds vs. few minutes). So WinWidth / WinHeight should be ignored if FullScreen = 1, if possible.
Ok
Posted: Thu Jul 17, 2008 11:28 pm
by Dreamer
Thanks.
Posted: Mon Jul 21, 2008 11:40 pm
by Dreamer
xnview wrote:Dreamer wrote:It's still the same. Sometimes it's (much) easier to edit one number in .sld file than re-create the whole slide show (few seconds vs. few minutes). So WinWidth / WinHeight should be ignored if FullScreen = 1, if possible.
Ok
Fixed in v1.94.
Closed.