Hello,
I use XnViewMP 0.86 on a Win7 System.
The panel IPTC-IIM/XMP -> Date/Time reads the date value for "Created date/time" correctly from metadata stored inside an image file.
But the time value is always set to 00:00. See attached screenshot.
This is very annoying because in case of only modifying one value and not taking care of date/time, time is reset to 00:00.
On the other hand it would be very helpful to allow also to enter seconds to the time value.
Best regards
Herb
Edit IPTC-IIM/XMP -> Date/Time
Moderators: XnTriq, helmut, xnview, Dreamer
Edit IPTC-IIM/XMP -> Date/Time
- Attachments
-
- Screenshot_Iptc.jpg (52.66 KiB) Viewed 761 times
Re: Edit IPTC-IIM/XMP -> Date/Time
Hello Pierre,
thanks for your investigations.
Image is sent via mail, because of size.
Best regards
Herb
thanks for your investigations.
Image is sent via mail, because of size.
Best regards
Herb
Re: Edit IPTC-IIM/XMP -> Date/Time
Hello Pierre,
thanks for the correction.
But please allow an additional comment: I looked again into the IPTC (and also XMP) standard and have seen that both request also a timezone value for time tags.
It would be wonderful if that would also be possible.
Best regards
Herb
thanks for the correction.
But please allow an additional comment: I looked again into the IPTC (and also XMP) standard and have seen that both request also a timezone value for time tags.
It would be wonderful if that would also be possible.
Best regards
Herb