"Status-Display" in XnConvert 1.10

[Peter2]

EDIT: I made a confusion between XnConvert 1.10 (this report) and MP 0.48 (original caption of the post). This thread can be erased.

Some small issues:

- The display of the status should have an auto-scroll to display always the latest lines in status.
- At minimum the status should display the end of the report when the batch is done.
- Progress bar displays 100% although there are some files remaining.

Peter

[xnview]

- The display of the status should have an auto-scroll to display always the latest lines in status.
- At minimum the status should display the end of the report when the batch is done.

When you move the scrollbar?

- Progress bar displays 100% although there are some files remaining.

Perhaps you have a lot of files? (a round problem)

[Peter2]

- The display of the status should have an auto-scroll to display always the latest lines in status.
- At minimum the status should display the end of the report when the batch is done.

When you move the scrollbar?

No, when the batch is working. The display should be a kind of "auto-scrolling": Always show the end of the log. And if "always" is not possible, then "show end of log at the end of batch job."

EDIT:
My report above is based on XnConvert 1.10. Current MP0.48 does it as suggested.

Perhaps you have a lot of files? (a round problem)

I don't think so, but I will watch it and report - if I can reproduce.

Peter

[Peter2]

I made a confusion between XnConvert 1.10 (this report) and MP 0.48 (original caption of the post). This thread can be erased.

Peter