Draw tool - Constrain line angle with Shift

Ideas for improvements and requests for new features in XnView MP

Moderators: XnTriq, xnview

Posts: 1561
Joined: Sun Apr 29, 2012 9:45 am
Location: Cheltenham, U.K.

Draw tool - Constrain line angle with Shift

Postby cday » Tue May 16, 2017 11:51 am

The Draw tool was a very welcome addition to XnView MP :D. But just one more request please:

In drawing programs, there is a convention when drawing a line that holding down the Shift key constrains the angle drawn to multiples of some angle value, typically 0 45 90 or 0 30 60 90 ...

That option would be a very useful addition, even if the angles drawn were constrained to horizontal or vertical initially...

Return to “MP - Suggestions”

Who is online

Users browsing this forum: No registered users and 1 guest