NConvert with Total Commander

Discussions on NConvert - the command line tool for image conversion and manipulation

Moderators: XnTriq, helmut, xnview

Post Reply
Nick_
Posts: 2
Joined: Wed Oct 18, 2017 9:10 am

NConvert with Total Commander

Post by Nick_ »

Hello!
I have many image files with different names and extensions. I need to delete ICC profile in some files, but this must be done only in copy of this files. Long names and special characters must be supported.

For example: <Original file №1>
Result: <Original file №1 without ICC profile> (its copy of file <Original file №1> but without ICC profile).

Image
Field parametres in Total Commander: -clean 4 %S

In this case original files is replaced, but I need to change only copy of source file. So, I need that NConvert first copy of source file with a new filename and than delete ICC profile.

How this problem can be done in Total Commander with NConvert?
User avatar
xnview
Author of XnView
Posts: 43326
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: NConvert with Total Commander

Post by xnview »

Is it possible to use short filename when you start an external app from TC?
Pierre.
Nick_
Posts: 2
Joined: Wed Oct 18, 2017 9:10 am

Re: NConvert with Total Commander

Post by Nick_ »

xnview wrote:Is it possible to use short filename when you start an external app from TC?
Yes it possible. It`s variable <%l>.
For example: "C:\PROGRA~1\LONGNA~1.EXE".
User avatar
xnview
Author of XnView
Posts: 43326
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: NConvert with Total Commander

Post by xnview »

Nick_ wrote:
xnview wrote:Is it possible to use short filename when you start an external app from TC?
Yes it possible. It`s variable <%l>.
For example: "C:\PROGRA~1\LONGNA~1.EXE".
not a solution, the problem is that NConvert use ASCII filename, not unicode...
Pierre.
Post Reply