Discussions on NConvert - the command line tool for image conversion and manipulation
Moderators: XnTriq, helmut, xnview
2 posts • Page 1 of 1
- Posts: 3891
- Joined: Sun Apr 29, 2012 9:45 am
- Location: Cheltenham, U.K.
If you include the following term in your code to extract the desired page I think you should get the result you want:punith8626 wrote:I need to extract a particular page from a multi-page tiff and rotate the same page in a single command how do I do it ?
Where 'degrees' is the angle you want.
Code: Select all
-rotate degrees : Rotate